ar2010s1271sd

Remove/install coolant pump

Tipo ar · tema 20.10 · versão 0110 · 2010-10-05

Válido para: ENGINES 646 in MODEL 636, 639

Não disponível em “pt”; apresentado em Inglês.

Onde se situa

Grupo funcional 1 Motor › 20 Arrefecimento do motor › 20.10 Bomba do líquido de arrefecimento, termostato do líquido de arrefecimento — Série 636 · Série 639 · Série 646

EinPAS 15 Motor › 15.25 Sistema de arrefecimento do motor › 15.25.30 Bomba/termostato/preaquecedor — Série 636 · Série 639 · Série 646

AR20.10-S-1271SD

Remove/install coolant pump

28.9.10

ENGINES 646 in MODEL 636, 639

Remove/install coolant pump

S20.10-4504-09

1 Coolant pump belt pulley

2 Coolant pump

3 Bolts, belt pulley to coolant pump

6 Coolant hose

7 Coolant pump screws to timing case cover

4 Guide pulleys

5 Coolant hose

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

1

Remove fan shroud

AR20.40-S-6800SD

2

Install a guard plate for radiator/condenser

Guard plate for radiator/condenser

WF58.50-S-0110-01S

3

Remove guide pulleys (4)

Two bolts attaching the coolant pump (2) are located behind the guide pulleys (4).

AR13.21-S-3350SD

4

Disconnect coolant hose (5) and coolant hose (6) at coolant pump (2)

To prevent leaks, check condition of coolant hoses and hose clamps, and replace if necessary.

5

Unscrew bolts for coolant pump to timing case cover (7)

*BA20.10-N-1003-01Q

6

Remove coolant pump (2)

Installation: Clean sealing surfaces and replace the gasket to prevent leaks.

7.1

Detach belt pulley of coolant pump (1)

Only if coolant pump (2) is replaced.

Unscrew bolt for belt pulley on the coolant pump (3).

*BA20.10-N-1001-01Q

Counterholder

*611589004000

8

Install in the reverse order

Checking

9

Inspecting cooling system for leaks

AR20.00-S-1010S

Coolant pump, coolant thermostat

Number

Designation

Engine 646
in model 636, 639

BA20.10-N-1001-01Q

Bolt, pulley to coolant pump

Nm

10

BA20.10-N-1003-01Q

Bolt, coolant pump to timing case cover

M6

Nm

14

Remove/install coolant pump

Counterholder

611 589 00 40 00

Documentos referenciados