ar0941s6817sd

Remove/install charge air cooler

Tipo ar · tema 09.41 · versão 0300 · 2011-01-10

Válido para: ENGINES 646 in MODEL 636, 639

Não disponível em “pt”; apresentado em Inglês.

Onde se situa

Grupo funcional 1 Motor › 09 Aspiração de ar, turboalimentação › 09.41 Tubo do ar de sobrealimentação/resfriamento do ar de sobrealimentação — Série 636 · Série 639 · Série 646

EinPAS 15 Motor › 15.30 Aspiração de ar/sobrealimentação › 15.30.45 Radiador do ar de sobrealimentação — Série 636 · Série 639 · Série 646

AR09.41-S-6817SD

Remove/install charge air cooler

17.12.10

ENGINES 646 in MODEL 636, 639

Remove/install charge air cooler

S09.41-4502-06

1 Charge air hoses

2 Bolt

3 Brackets

4 Charge air cooler

Remove/install charge air cooler

S09.41-4533-10

4 Charge air cooler

5 Clamps

Modification notes

27.10.10

Method extended

Operation steps 1.1 and 2

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1.1

Remove front bumper

Only without code (XZ1) Model generation 1

AR88.20-S-2000S

1.2

Loosen front bumper in the lower area on the fender liners

Only with code (XZ1) Model generation 1

AR88.20-S-2000S

To do this remove expansion clip on the left and right.

2

Remove air inlet grille below

Only with model 639.8 with code (XZ1) Model generation 1

3

Take off bottom engine compartment panel at front

Only on model 636,

Model 639.7/8 as of vehicle identification number (VIN) 055347

AR61.20-S-1105-02S

4

Remove charge air hoses (1)

Oil traces and low oil quantities in the charge air hoses (1) coming from the crankcase ventilation are permissible.

Installation: Observe installation position of clamps (5). Check clamps (5), replace if necessary.

5

Unscrew bolts (2) from charge air cooler (4) on right and left

If applicable, slightly press side cooler covers to side.

6

Remove charge air cooler (4) downward.

For this purpose pull brackets (3) out toward front on right and left and unhook from charge air cooler (4).

7

Install in the reverse order

Checking

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it moving off. Wear closed and close-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

8

Check for leaks with engine running

Documentos referenciados