si3525g0001a

Service information: Vent lines at hub reduction axle

Typ si · temat 35.25 · wersja 0100 · 2003-06-17

Dotyczy: MODEL 427 with FRONT AXLE 737.42 with REAR AXLE 747.42 MODEL 437 with FRONT AXLE 737.2 /42 with REAR AXLE 747.2 /42

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.25 Belka osi — Seria 427 · Seria 437

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.60 Zwolnica koła/zewnętrzna przekładnia planetarna — Seria 427 · Seria 437

EinPAS 45 Dane/ informacje › 45.20 Informacje/ działania › 45.20.20 Informacje serwisowe — Seria 427 · Seria 437

Dotyczy też silników/skrzyń biegów: 737 2**, 737 42*, 747 2**, 747 42*

SI35.25-G-0001A

Service information: Vent lines at hub reduction axle

27.10.00

MODEL 427 with FRONT AXLE 737.42 with REAR AXLE 747.42

MODEL 437 with FRONT AXLE 737.2 /42 with REAR AXLE 747.2 /42

Modification notes

27.10.00

Supersedes STIN 35.10G014 dated 26.10.2000

SI file 35/54

Service information: Vent lines at hub reduction axle

G35.10-3110-02

Modified routing at rear axle, front axle by analogy.

The routing of the vent line at the hub reduction axle has been modified in the case of the axle model designations listed above. The vent lines are connected to each hub reduction axle, instead of to the rear vent hole at the front hole.

The production breakpoint was implemented in the case axle model designation 737/747.2 with VIN437105-1W-195308 and in the case of axle model designation 737/747.42 with VIN427115-1W-196140.

If a complaint about "Oil escaping through vent" is received, the line can also be re-routed on preceding VINs.