P83.70-2804-01
1 Cut exhaust line and end section with exhaust line (14a) as shown in figure.
P83.70-2806-01
2 Fasten exhaust muffler (21) to left perforated strap (see magnified section) with M6x20 screw and collar nut.
3 Fasten exhaust line (14) between heater (A6) and exhaust muffler (2) with one pipe clamp each and align as shown in figure.
Using a punch make a 3mm dia. hole in the lowest part of the exhaust line (14).
4 Pull two red spacers (20) over exhaust line with end section (14a) as shown in figure.
5 Fasten exhaust line with end section (14a) to exhaust muffler (21) with pipe clamp.
6 Fasten exhaust line with end section (14a) on right perforated strap with pipe clamp (see arrow) and M6x20 mm screw.
P83.70-2787-01
7 Cut out 50 mm dia. hole for end section of exhaust line in wheelhouse inner fender according to dimensions specified.
P83.70-2788-01
8 Close cutout in wheelhouse inner fender with cover plate.
9 Use cover plate as template for mounting holes (see arrows).
10 Drill holes with 4 mm dia. bit and fasten cover plate with two 4.5x15 mm sheet metal screws.