Retrofit GPS antenna for Communication and Navigation System (CNS) with digital radio (DAB)

AZ82.85-S-0012-04E

Retrofit GPS antenna for Communication and Navigation System (CNS) with digital radio (DAB)

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Model

447.6/7

1

Bend metal base (1) by approx. 90° as shown.

 Observe dimension (A).

 The metal base (1) is included in the parts kit.

1

Metal base

2

GPS antenna

3

Green connector socket

a

Dimension (approx. 25 mm)

2

Place metal base (1) on instrument panel with positive fit, as shown, and bond to surface.

 The bonding area for the metal base (1) on the instrument panel must be dry and free of dust and grease.
This helps to prevent adhesion problems.

 To do so, remove the protective foil from the metal base (1).

3

Place GPS antenna (2) on metal base (1), as shown, and bond to surface.

 To do so, bond double-sided adhesive tape to the GPS antenna (2) and remove the protective foil from the adhesive tape.

4

Route electric line of GPS antenna (2), as shown, in instrument panel to installation location of Communication and Navigation System (CNS) head unit.

 Do not kink the electric line of the GPS antenna (2) and ensure chafe-free routing.
Prevent damage.

5

Secure electric line of GPS antenna (2) section by section to factory-installed electrical wiring harness using cable ties.

 The green connector socket (3) on the electric line of the GPS antenna (2) is attached during installation of the CNS head unit.