P82.70-6501-09
1 | Template | 3 | Adhesive fabric tape | ||||
2 | Lower section of dashboard | 4 | Center console |
P82.70-6500-09
Shown on MODEL 451.3 |
2 | Lower section of dashboard | 7 | Rubber guide | 11 | Bolts | ||
4 | Center console | 8 | Cover | 12 | Telephone mounting bracket | ||
5 | Hole | 9 | Console top section | 13 | Coin holder (with model 451.3) | ||
6 | Holes | 10 | Console bottom section |
| Remove | ||
1 | Remove dashboard bottom section (2) and place onto a suitable base | ||
| |||
2 | Remove center console (4) and place onto a suitable base | ||
| |||
3 | Unclip coin holder (13) from center console (4) and remove | Model 451.3 (except 451.39) | |
| Install | ||
4 | Cut template (1) included in delivery contents along broken lines (arrows A, B) | ||
5 | Position template (1) as shown on instrument panel lower section (2) and fix in place using suitable duct tape (3) | ||
6 | Place dashboard bottom section (2) on a suitable wooden support and align | ||
7 | Drill holes (6) with a diameter of 12 mm corresponding to the markings (arrows C) | ||
8 | Remove template (1) | ||
9 | Install dashboard bottom section (2) | ||
| |||
10 | Install cockpit switch group | ||
| |||
11 | Install vertical strut paneling | ||
| |||
12 | Drill a hole (5) with a diameter of 37 mm in the marked area (arrow D) on the right side of the center console (4) | The marking (arrow D) is embossed into the center console (4). | |
Graduated drill | |||
13 | Install center console (4) | ||
| |||
On MODEL 451.4 the power soft top switch is installed at a later stage. | |||
14 | Position console top section (9) on console bottom section (10) and tighten with bolts (11) | ||
15 | Insert rubber guide (7) into holes (6) in dashboard bottom section (2) | Pay attention to installation position. | |
16 | Insert telephone mounting bracket (12) in rubber guide (7) and clip into hole (5) at center console (4) | ||
17 | Clip cover (8) into telephone mounting bracket (12) | Counterhold center console (4) from behind through the opening of coin holder (13) or power soft top switch. | |
18.1 | Clip coin holder (13) into center console (4) | Model 451.3 (except 451.39) | |
18.2 | Install power soft top switch | Model 451.4 (except 451.49) | |
| |||
19 | Enter special equipment in on-line vehicle data card via vehicle documentation system (VeDoc) | Add CODE C10 (Telephone console (DFO)). | |
20 | Document retrofitted equipment in VeDoc | Attach note "Telephone mounting bracket retrofitted as per AZ82.70-P-0010MCC" under field organization texts to design group 82. |
450 589 00 28 00
Graduated drill