P82.61-2489-06
1 Route lead in vehicle along existing wires as shown in figure.
2 Provide gray/yellow (gr/ge) lead for reverse lamp signal with contact spring.
1 Traffic Pro navigation system
11 Antenna extension lead
12 GPS antenna connector
gr/ge Lead for reverse lamp signal
P82.61-2020-01
3 Insert contact spring of lead for reverse lamp signal (2) into radio connector (A), chamber 2.
P82.61-2256-01
4 Route gray/yellow (gr/ge) lead for reverse lamp signal from radio shaft to shift gate.
5 Check gray/yellow (gr/ge) lead from reverse lamp switch from standard wiring harness and expose.
If wire colors deviate, refer to wiring diagram.
6 Solder gray/yellow (gr/ge) lead for reverse lamp signal to gray/yellow (gr/ge) lead from standard wiring harness and insulate.
P82.61-2257-01
7 Route antenna extension lead (11) in right footwell to right wiring duct as shown in figure.
P82.61-2258-01
8 Route lead (11) to rear in right wiring duct.
9 Route lead (11) through rear wall into trunk.
P82.61-2259-01
10 Route lead (11) in trunk on right to trunk lid as shown in figure and fasten with cable straps (arrows).
11 Fasten connector (12) with adhesive felt in trunk lid.
P82.61-2479-01
12 Connect antenna extension lead (11) to navigation system as shown in figure.