ar9720d050003f

Processing permanent underbody protection for painting

Typ ar · temat 97.20 · wersja 0100 · 2013-02-13

Dotyczy: MODEL 909

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 97 Uszczelnienie nadwozia, zabezpieczenie antykorozyjne › 97.20 Konserwacja — Seria 909

EinPAS 40 Konserwacja/ lakierowanie › 40.20 Zabezpieczenie antykorozyjne › 40.20.1 Informacje podstawowe — Seria 909

EinPAS 40 Konserwacja/ lakierowanie › 40.20 Zabezpieczenie antykorozyjne › 40.20.45 Zabezpieczenie podwozia — Seria 909

AR97.20-D-0500-03F

Processing permanent underbody protection for painting

MODEL

909

Permanent underbody protection agent (synthetic rubber), dark gray

The permanent underbody protection agent is designed on a synthetic rubber basis and is suited for processing fender bottom sections, underbody as well as transitions to original standard PVC underbody protection.

Not suitable for sealing work (joint sealing).
Blow through spray gun with solvent after use.
Ensure that air hole on screw-in thread is free.

Permanent underbody protection (water-base dispersion), gray

This permanent underbody protection agent is a water-base dispersion suitable for use on the underbody, fender bottom sections as well as outer surface. For processing on the outer surface (e.g. front fender below bumper, longitudinal members at entry) thin material with 5 % water to achieve better coverage.

For transitions to original standard PVC underfloor protection and for sealing work (seam sealing) use this permanent underfloor protection.
Otherwise it may cause insufficient adhesion and crack formation.

Processing permanent underfloor protection agent for painting

1

Clean all areas to which permanent underbody protection agent is to be applied.

Remove wax and oil residues as well as loose PVC pieces.
Grind corroded points down to bare metal and prime.

A hot air gun and flat nozzle with integrated scraper or rotating wire brushes are suitable for removing the PVC material.

2

Apply permanent underbody protection agent uniformly with spray gun.

Do not spray permanent underbody protection agent on assemblies.
Otherwise malfunction can occur.

After completion of work, thoroughly clean working equipment with water as well as before reusing, moisten air flap with mineral oil.
Otherwise spray mist can dry and impair the function of the working equipment.

Observe drying time before overpainting.