ar9160s0680a

Remove/install passenger airbag unit

Typ ar · temat 91.60 · wersja 0109 · 2019-03-29

Dotyczy: Model 638 with code SA6 (Airbag, co-driver)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 91 Fotele, leżanki, system zabezpieczenia pasażerów › 91.60 Poduszki powietrzne, system ochrony pieszych — Seria 638

EinPAS 27 Bezpieczeństwo bierne/ systemy zabezpieczające przed skutkami wypadków › 27.16 Poduszka powietrzna › 27.16.20 Poduszka powietrzna — Seria 638

AR91.60-S-0680A

Remove/install passenger airbag unit

18.03.2019

Model

638

with code SA6 (Airbag, co-driver)

Remove/install passenger airbag unit

Shown on model 638 except models 638.094/194/294

1

Clips

2

Cover

3

Front passenger airbag unit

4

Screw

S91.60-2001-06

Remove/install

Warning

Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.

Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.

AS91.00-Z-0001-01A

Topical note

Notes on battery

AH54.10-P-0001-01A

Topical note

Notes on performing repair, body work and welding on vehicles with airbags and RTE units

AH91.00-P-0002-01M

Assessment of airbag and belt tensioner units in accident vehicles

AH91.00-P-0006-01B

Legal requirements on handling and storing airbags and emergency tensioning retractor units

AH91.00-P-0004-01A

1

Disconnect ground line of battery

AR54.10-S-0005A

Installation: -Code radio.
-Set time.

See

operator's manual.

2

Remove right air vent

AR83.10-S-4740A

3

Unclip cap (2) of front passenger airbag unit (3)


Model 638 (except 638.094/194/294)You must not pull on the cap:
Otherwise the predetermined fracture points may break.

Model 638 (except 638.094/194/294)
To do so, press expansion clips (1) together from rear with a suitable tool and push out.

Model 638.094/194/294
Pull out cap carefully.

The defective airbag and seat belt tensioner units must be disposed of in a proper and environmentally-friendly manner.

4

Remove cover below instrument panel on front passenger side

5

Disconnect connector coupling (R2.1) at squib (R2)

6

Unscrew screws (4), remove front passenger airbag unit (3)

Remove screws (4) on both sides.

Screw/bolt, front passenger airbag unit to instrument panel carrier

*BA91.60-N-1005-01D

7

Install in the reverse order

Airbag

Number

Designation

Model 638

BA91.60-N-1005-01D

Screw/bolt, front passenger airbag unit to instrument panel carrier

Nm

8

Powiązane dokumenty