AR91.10-P-1200R | Remove/install front seat frame trim panels | 30.10.08 |
MODEL 230.4 except CODE (P99) "AMG Black Series" special model
MODEL 230.4
with CODE (P99) Special model "AMG Black Series"
with CODE (494) USA version
P91.10-2329-09
Shown on front seat with code (404) Left multicontour seat
1 Front seat frame trim
2 Bolts
3 Electrical connector (with code (404) Left multicontour seat or code (405) Right multicontour seat)
4 Bracket
5 Belt end fitting cover
6 Bracket
7 Cap
8 Screw
| Remove/install | ||
1 | Switch on ignition | ||
2 | Move left or right front seat upwards and to the rear | ||
3 | Move backrest into upright position | ||
4 | Switch off the ignition and remove the transmitter key from the EIS control unit | On vehicles with code (889) Keyless-Go, press KEYLESS-GO start/stop button repeatedly until ignition is switched off. Remove Keyless-Go chip card or transmitter key from vehicle and store beyond the reach of the transmitter (at least 2 m). | |
5 | Open flap of front seat stowage compartment | ||
6 | Remove bolts (2) in stowage compartment | Installation: Adjust striker of stowage compartment flap. | |
7 | Remove stowage compartment downwards | ||
8 | Unclip cap (7) from belt end fitting trim (5) using mounting wedge | | |
9 | Detach locking plate beneath cap (7) | Installation: Replace locking plate. | |
10 | Remove bolt (8) from belt end fitting trim (5) | ||
11 | Unclip belt end fitting trim (5) from bracket (6) and remove | ||
12 | Unclip front seat frame trim (1) from bracket (4), lift and remove | ||
13 | Disconnect electrical connector (3) from left front multicontour backrest switch group or right front multicontour backrest switch group | With front seat with code (404) Left multicontour seat or | |
Installation: Pay attention to washer beneath the front seat frame trim (1). | |||
14 | Install in the reverse order |
Mounting wedge
110 589 03 59 00