ar8840p3201mfa

Remove/install engine hood catch

Typ ar · temat 88.40 · wersja 0102 · 2019-03-20

Dotyczy: Model 118, 177, 247

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 88 Części dobudowane, klapy zewnętrzne › 88.40 Pokrywa komory silnika, pokrywa przednia — Seria 118 · Seria 177 · Seria 247

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 118 · Seria 177 · Seria 247

AR88.40-P-3201MFA

Remove/install engine hood catch

20.03.2019

Model

118, 177, 247

Remove/install engine hood catch

P88.40-3436-08

1

Bolts

4

Limit switch

2

Electrical connector

5

Catch hook

3

Engine hood catch

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on safety-relevant components

AH00.00-Z-0019-01A

Remove/install

1

Open engine hood

2

Release and disconnect electrical connector (2)

3

Mark setting position of hood catch (3) and remove screws (1)

Bolt, engine hood catch lower section to radiator crossmember

*BA88.40-P-1001-01F

4

Lift catch hooks (5) and remove limit switch (4)

5

Unhook cable from hood catch (3) and remove hood catch (3)

6

Install in the reverse order

Engine hood

Number

Designation

Model 118, 177, 247

BA88.40-P-1001-01F

Bolt, engine hood catch lower section to radiator crossmember

Nm

12

Powiązane dokumenty