ar8840d2546ts

Remove/install insulation on hood

Typ ar · temat 88.40 · wersja 0100 · 2017-08-08

Dotyczy: Model 907, 910

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 88 Części dobudowane, klapy zewnętrzne › 88.40 Pokrywa komory silnika, pokrywa przednia — Seria 907 · Seria 910

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.25 Element tłumiący/okładzina dolna/uszczelnienie/osłona dolna › 35.25.40 Wygłuszenie/ ekranowanie/ mata tłumiąca — Seria 907 · Seria 910

AR88.40-D-2546TS

Remove/install insulation on hood

24.07.2017

Model

907, 910

Remove/install insulation on hood

1

Insulation

2

Retaining clips

3

Engine hood

D88.40-1134-05

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Remove insulation (1) from hood (3)

For this purpose, remove retaining clips (2).

Installation: Check retaining clips (2) for damage.

Clip remover

*452589016300

Depending on findings

Replace damaged retaining clips (2).

2

Install in the reverse order

Remove/install insulation on hood

452 589 01 63 00

Clip remover

Powiązane dokumenty