ar8810d1322ts

Remove/install front section of front fender liner

Typ ar · temat 88.10 · wersja 0100 · 2017-12-15

Dotyczy: Model 907, 910

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 88 Części dobudowane, klapy zewnętrzne › 88.10 Błotnik — Seria 907 · Seria 910

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.37 Błotnik › 35.37.40 Błotnik wewnętrzny — Seria 907 · Seria 910

AR88.10-D-1322TS

Remove/install front section of front fender liner

30.11.2017

Model

907, 910

Remove/install front section of front fender liner

Shown on model 907 left, front wheel removed

1

Front section of fender liner

2

Nuts

3

Nut

4

Bolts

5

Expansion rivet

D88.10-0001-06

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Remove/install

1

Raise vehicle

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

2

Loosen nut (3)

Installation: Check nut (3) for damage.

Depending on findings

Replace damaged nut (3).

3

Unscrew nuts (2)

Installation: Check nuts (2) for damage.

Depending on findings

Replace damaged nuts (2).

4

Remove expansion rivet (5)

Installation: Check expansion rivets (5) for damage.

Depending on findings

Replace damaged expansion rivets (5).

5

Remove bolt s (4)

6

Remove front section of fender liner (1)

7

Install in the reverse order

Powiązane dokumenty