AR86.10-P-0101A | Remove/install fire extinguishing system control unit | 30.4.09 |
MODEL 463.236 /248
with CODE (979) Special protection version
with CODE (ZS6) Special protection version FB6
with fire extinguishing system
MODEL 463.236 /248
with CODE (979) Special protection version
with CODE (ZS7) Special protection version FB7
with fire extinguishing system
P86.10-2101-11
1 Plug connector
N100 Fire extinguishing system control unit
| Remove/install | ||
1 | Disconnect ground line from battery (G1) with battery main switch (S25/20) | See Operator's Manual | |
2 | Open flap on additional battery paneling (G1/3) | In load compartment on right side. | |
3 | Disconnect connector (1) from fire extinguishing system control unit (N100) | ||
4 | Unscrew and remove fire extinguishing system control unit (N100) from rear wall | ||
5 | Install in the reverse order | ||
6 | Connect STAR DIAGNOSIS, read out DTC memory and erase if required | DTC's may be stored as a result of interrupted electrical connectors, simulation during removal and installation work or during test work. It is necessary to read these out and erase them with the STAR DIAGNOSIS diagnosis system. | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
7 | Perform basic programming |
Powiązane dokumenty
- ad0000p200004a Podłączanie STAR DIAGNOSIS, odczytywanie pamięci usterek
- ad0000p200004a
- ar0019p0200p Przeprowadź programowanie podstawowe.