ar8370s5682a

Removing and installing flame monitor

Typ ar · temat 83.70 · wersja 0106 · 2010-09-15

Dotyczy: MODEL 638.0 /1 /2 up to 15.11.97 with CODE (H12) Warm water auxiliary heater D5W or B5W

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 83 Klimatyzacja › 83.70 Ogrzewanie w czasie postoju, dodatkowe, nagrzewnica dodatkowa — Seria 638 (modele 0**, 1**, 2**)

EinPAS 39 Ogrzewanie/ wentylacja/ chłodzenie › 39.25 Ogrzewanie postojowe/ ogrzewanie dodatkowe › 39.25.12 Czujnik/ przełącznik/ wiązka przewodów — Seria 638 (modele 0**, 1**, 2**)

AR83.70-S-5682A

Removing and installing flame monitor

7.9.10

MODEL 638.0 /1 /2 up to 15.11.97 with CODE (H12) Warm water auxiliary heater
D5W or B5W

Removing and installing flame monitor

S83.70-2007-06

1 Connector box

B96 Flame monitor

X167 12-pin connector

Removal, installation

1

Disconnect ground cable from battery

Installation: Code radio and set clock

See

Owner's Manual

AR54.10-S-0005A

Danger!

Fuel vapors present an explosion hazard. Combustion gases are toxic when inhaled. Heater can cause severe burns during and after operation

Do not start up or operate stationary heaters or engines with heater boosters in closed rooms or in the vicinity of service stations. Allow heater to cool off after operation and wear protective gloves.

AS83.70-Z-0002-01A

2

Lower heater with support

AR83.70-S-5330-01A

*BA83.70-N-1005-01A

3

Remove connector box lid (1)

Installation: Make sure the joints are correctly seated

4

Disconnect 12-pin connector (X167) and connector box

5

Open connector box and remove pins 7
and 9

Installation: Pay attention to the location of the connectors

AR83.70-S-5940-01A

6

Unscrew flame monitor (B96)

*BA83.70-N-1003-01A

7

Reinstall in opposite order

8

Carry out function test

AR83.70-S-5302-02A

Auxiliary heater

Number

Designation

Model
638

BA83.70-N-1003-01A

Flame monitor in burner

Nm

3

BA83.70-N-1005-01A

Support on floor assembly

Nm

8

Powiązane dokumenty