Teach in stationary heater radio remote control transmitter

AR83.70-S-0013-01EE

Teach in stationary heater radio remote control transmitter

Model

447

with code HY2 (Radio remote control for auxiliary air heater)

with code HZ1 (Auxiliary heater (warm air))

except code H12 (Auxiliary hot-water heater)

1

Switch on ignition.

2.1

Model 447 except code E28 (Additional battery for retrofit consumer)
Remove electrical fuse 85 (K40/11f85) from firewall fuse and relay module (K40/11).

 If the electrical fuse 85 (K40/11f85) is removed for approx. 5 s, the illumination of the stationary heater timer goes out and the existing settings are reset.

2.2

Model 447 with code E28 (Additional battery for retrofit consumer), except code ZK7 (MARCO POLO equipment line)
Remove electrical fuse 322 (K40/12f322) from front passenger footwell fuse and relay module (K40/12).

 If the electrical fuse 322 (K40/12f322) is removed for approx. 5 s, the illumination of the stationary heater timer goes out and the existing settings are reset.

2.3

Model 447 with code HY2 (Radio remote control for auxiliary air heater), code HZ1 (Auxiliary heater (warm air)) and with code ZK7 (MARCO POLO equipment line)
Remove electrical fuses 320 (K40/12f320) and 322 (K40/12f320) from front passenger footwell fuse and relay module (K40/12).

3

After a waiting time of 5 s, install electrical fuse 85, 320 or electrical fuse 322 again.

 Model 447 with code HY2 (Radio remote control for auxiliary air heater) and with code HZ1 (Auxiliary heater (warm air)), except code ZK7 (MARCO POLO equipment line)
Approx. 5 s after installation, the indication ini appears in the display (1) of the stationary heater timer (N34).
Then the time 12:00 is shown in the display (1).
After another 10 s, the indication AddP appears in the display (1).
The warm air stationary heater radio remote control transmitter can only be taught in when AddP is shown in the display (1).

4

Press and hold button (2) at the warm air stationary heater radio remote control transmitter (A8/3) until indicator lamp (3) lights up red, then immediately release button (2).

 The indicator lamp (3) starts to flash alternately red and green. A link has now been established between the warm air stationary heater radio remote control transmitter (A8/3) and the air stationary heater radio remote control receiver.

5

While the indicator lamp (3) is flashing alternately red and green, press the button (4) briefly (do not hold it down).

 The indicator lamp (3) flashes green twice if the teach-in was completed successfully.

6

Set the current weekday and time on the stationary heater timer.

7

Switch off ignition.