S82.62-4607-79
1 | Rear headliner | 4 | High-frequency diplexer | 7 | Assembly clamp | ||
2 | Electrical connector | 5 | Carrier | 8 | Tweeter | ||
3 | Cable tie | 6 | Speaker cover |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Remove rear roof lining (1). | ||
2 | Disconnect electrical connection (2). | ||
3 | Separate cable tie (3) and remove high-frequency diplexer (4) from carrier (5). | ||
4 | Heat up adhesive in area around fastening points of speaker cover (6) and remove speaker cover (6). | ||
| 000 588 00 84 00 Heat gun | ||
| |||
5 | Remove assembly clamp (7) from tweeter (8). | ||
6 | Heat up adhesive in area around fastening points of tweeter (8) and remove tweeter (8) with high-frequency diplexer (4) through the cutout on the front side of the rear roof lining (1). | ||
| 000 588 00 84 00 Heat gun | ||
| |||
| Clean | ||
7 | Remove adhesive residue from rear roof lining (1). | ||
8 | Clean rear roof lining (1) in area of bonding positions until grease-free. | MB plastic cleaner | |
| Install | ||
9 | Install tweeter (8) with high-frequency diplexer (4) through cutout on front side of rear roof lining (1) and position in the rear roof lining (1). | ||
10 | Attach assembly clamp (7) to tweeter (8). | ||
11 | Stick tweeter (8) to rear roof lining (1). | Adhesive PATTEX transparent hot sticks | |
12 | Attach high-frequency diplexer (4) to carrier (5) with new cable tie (3). | ||
13 | Connect electrical connector (2). | ||
14 | Install speaker cover (6) and stick to rear roof lining (1). | Adhesive PATTEX transparent hot sticks | |
15 | Install rear roof lining (1). | ||
Carry out function test of mid-range speaker and tweeter (8) after the rear roof lining (1) is attached and the mid-range speaker and tweeter (8) are connected. |
Powiązane dokumenty
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ar6830s7608ee
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.
- ws5400p0049b