Remove/install additional washer fluid reservoir of windshield washer system

AR82.35-P-6001TX

Remove/install additional washer fluid reservoir of windshield washer system

12.10.04

 

Remove/Install

1

Open engine hood and raise to vertical position

AR88.40-P-1000TX

2

Remove housing from combination filter

AR83.00-P-1000TX

3

Remove expansion rivet (2)

4

Unscrew nuts (3)

5

Unclip cover (4)



*110589035900

6

Pull filler neck (5) from washer fluid reservoir

 Installation: replace seal of filler neck (5) on washer fluid reservoir.

7

Pull vent hose (6) off of filler neck (5) and remove filler neck (5)

8

Detach water trough drain hose (7) and put to one side

9

Unscrew nuts (8) and remove air duct (9)

10

Unscrew nut (10)

 Installation: Replace self-locking nut (10).

11

Remove auxiliary washer fluid reservoir (1) from engine compartment, as far as it takes for the connector hose (12) connection to be accessible

12

Disconnect connector hose (12) on auxiliary washer fluid reservoir (1) and remove auxiliary washer fluid reservoir (1)

 Collect washer fluid which flows out.

 Installation: Ensure that the supports (11) are properly seated.

13

Install in the reverse order

14

Fill washer fluid reservoir



Inspect fluid level of windshield washer system, adjust to correct level

AP82.35-P-8210TX