ar8235d6000tsf

Remove/install washer fluid reservoir of windshield washer system

Typ ar · temat 82.35 · wersja 0100 · 2018-05-24

Dotyczy: Model 910

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 82 Układ elektryczny, nadwozie › 82.35 Spryskiwacze — Seria 910

EinPAS 36 Widoczność › 36.30 Wycieraczki/ spryskiwacze › 36.30.41 Pompa/ zbiornik/ wymiennik ciepła — Seria 910

AR82.35-D-6000TSF

Remove/install washer fluid reservoir of windshield washer system

09.05.2018

Model

910

Remove/install washer fluid reservoir of windshield washer system

Shown with engine 651 except code W78 (Window in liftgate or rear-end door with wiper and washer system)

1

Washer fluid reservoir

2

Bolts

3

Electrical connector

4

Washer fluid line

5

Pump

6

Elastomer bearing

D82.35-0011-76

Danger

Risk of fire and explosion caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin.

Wear protective clothing and tight-fitting safety glasses. No open flames, fire or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children.

AS82.35-Z-0001-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

2

Disconnect electrical connector from left front lamp unit.

AR82.10-D-4733TS

3

Unscrew bolts (2).

4

Disconnect electrical connector (3) of fill level sensor.

5

Unclip washer fluid line (4) of windshield washer system at front from the guide in the washer fluid reservoir (1).

6

Unclip washer fluid line of windshield washer system at rear from the guide in the washer fluid reservoir (1).

Model 910
with code W78 (Window in tailgate or hinged rear door with wipe/wash system)

7

Remove pump (5) from washer fluid reservoir (1).

Collect escaping washer fluid.

8

Guide washer fluid reservoir (1) upwards out of elastomer bearing (6).

9

Check elastomer bearing (6) and seal of pump (5).

If there is a problem,

Replace elastomer bearing (6) or seal of pump (5).

10

Install in the reverse order.

11

Correct fluid level of windshield washer system.

AP82.35-D-8210TS

Check

12

Perform function test of the windshield washer system.

AP82.30-D-8252TS

Powiązane dokumenty