Remove/install wiper motor

AR82.30-P-6800RG

Remove/install wiper motor

15.03.2016

Model

190

1

Cover

2

Expansion rivet

8

Cover

B31

Air quality sensor

M6/6

Master wiper motor

M6/7

Slave wiper motor

3

Expansion rivet

4

Screw

5

Bolts

6

Bracket

7

Water drain duct

M6/6

Master wiper motor

9

Housing

10

Bolts

M6/7

Slave wiper motor

 Danger !

Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

 

Remove/install

1

Remove wiper arm

AR82.30-P-6100RQ

2

Remove expansion rivets (2)

 Clip remover

*452589016300

3

Take off cover (1)

 Loosen sealing on left and right. Sealing of cover (1) is only removed completely during replacement.

4

Remove expansion rivets (3)

 Clip remover

*452589016300

5

Remove bolts (4)

 Press water drain duct (7) to one side.

6

Disconnect electrical connector and remove master wiper motor (M6/6) with bracket (6)

 Lift master wiper motor (M6/6) with bracket (6) until electrical connector at master wiper motor (M6/6) is accessible.

7

Unscrew bolts (5) and remove bracket (6)

Only when replacing master wiper motor (M6/6) or bracket (6)

 Bolt, wiper motor fastening

*BA82.30-P-1001-01N

8

Remove air quality sensor (B31) from cover (8) and place to one side with electrical lines connected

9

Unclip cover (8) from housing (9) and remove

10

Remove screws/bolts (10)

 Bolt, wiper motor fastening

*BA82.30-P-1001-01N

11

Disconnect electrical connector and remove slave wiper motor (M6/7)

 Press housing (9) to one side and guide out slave wiper motor (M6/7) until electrical connector is accessible.

12

Install in the reverse order

 Windshield wiper

Number

Designation

Model 190

BA82.30-P-1001-01N

Bolt, wiper motor fastening

Nm

10