1 | Windshield wiper system |
2 | Electrical connector |
3 | Screw |
4 | Nut |
M6/1 | Wiper motor |
P82.30-3522-06
Warning | Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Set wiper motor (M6/1) to upper position with vehicle diagnosis system. | ||
| |||
The upper position is only intended for installing the wiper arm on the driver's side. | |||
2 | Remove cover for air/water duct. |
| |
Model 118, 177 | |||
Installation: | |||
3 | Release and disconnect electrical connector (2) at wiper motor (M6/1). | ||
4 | Remove bolt (3) . | Screw, wiper motor holder to body | |
5 | Remove nuts(4). | Nut, windshield wiper system to body | |
6 | Remove windshield wiper system (1). | ||
7 | Install in the reverse order. | ||
Initial startup | |||
8 | Commission wiper motor (M6/1). | If the wiper motor (M6/1) is replaced. | |
|
Powiązane dokumenty
- ad0000p200006mfa
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ar8310p1411mfa
- ar8310p1411mfb
- as8230z000101a Niebezpieczeństwo zakleszczenia lub zmiażdżenia, w skrajnym przypadku obcięcia kończyn podczas prac przy układzie mechanicznym wycieraczki