Remove/install fan for lamp unit

AR82.10-P-4742FR

Remove/install fan for lamp unit

26.06.2018

Model

257

with code P35 (Light Package)

Model

290

Shown on right front lamp unit, without cap

1

Housing

4

Cover

2

Electrical connector

E1m4

Left front lamp unit fan motor 1

3

Electrical wiring harness

E2m4

Right front lamp unit fan motor 1

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A



Remove

1

Remove front lamp unit.

AR82.10-P-4733FR

 Caution

Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics

Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated.

AS00.00-Z-0001-02A

2.1

Cut out housing (1) of lamp unit along imprinted broken line using the hot knife.

If the cap is not installed.



000 588 03 84 00 Hot knife

WS82.00-P-0026B


Carefully cut out the housing (1).
Otherwise, the component parts in the housing (1) may be damaged.

2.2

Remove bolts from cap.

If the cap is installed.

3

Remove section of housing (1) or cap far enough until the lamp unit fan motor 1 (E1m4, E2m4) is accessible.

4

Disconnect electrical connector (2) from lamp unit fan motor 1 (E1m4, E2m4).

5

Unclip electrical wiring harness (3) (arrow A).

 Dismantling tool

*000589956300

6

Release cover (4) from catch hook (arrows B), remove it then remove the lamp unit fan motor 1 (E1m4, E2m4).



Install

7

Insert lamp unit fan motor 1 (E1m4, E2m4) into cap and install the cover (4).


Make sure that the cover (4) latches properly into place.
Otherwise, the lamp unit fan motor 1 (E1m4, E2m4) may be damaged.

8

Clip electrical wiring harness (3) onto cap (arrow A).

9

Connect electrical connector (2) to fan motor 1 of lamp unit (E1m4, E2m4).

10

Position and tighten the cap.

11

Install front lamp unit.

AR82.10-P-4733FR