AR82.10-P-4081TX | Remove/install headlight beam adjustment control unit | 11.10.04 |
MODEL 219.3
with CODE (615) Bi-xenon headlamp unit with integrated cornering lamps
with CODE (616) Bi-xenon headlamp unit with integrated asymmetrical cornering lamps
P82.10-3923-07
1 Tie strap
2 Ventilation grille
3 Rear floor covering
4 B-pillar paneling
N71 Headlamp range adjustment control unit
5 Electrical wiring harness
6 Nut
7 Electrical connector
| Remove/Install | ||
1 | Remove front and rear door sill moldings | On right side of vehicle. | |
2 | Remove right front seat | ||
3 | Remove tie strap (1) | Installation: replace tie straps (1). | |
4 | Unclip vent grille (2) and remove | ||
5 | Pull out rear floor covering (3) under the B-pillar paneling (4) | ||
6 | Fold up rear floor covering (3) far enough to the center console until the headlamp range adjustment control unit (N71) is accessible. At the same time route the electrical wiring harness (5) through the opening in the rear floor covering (3) | Note the electrical wiring harness (5). This can rip the | |
7 | Unscrew nuts (6) | ||
8 | Detach electrical connector (7) and remove headlamp range adjustment control unit (N71) from vehicle | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
9 | Install in the reverse order | ||
10.1 | Check headlamp adjustment | Only when installing a new headlamp range adjustment control unit (N71). | |
| Check and correct headlamp adjustment |
Powiązane dokumenty
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ap8210p8260tx Kontrola i regulacja ustawienia reflektorów
- ar6830p4100tx
- ar9110p1000tx