Remove/install bulbs of headlamp unit · ar8210p1201mfb · Mercedes-Benz WIS

AR82.10-P-1201MFB

Remove/install bulbs of headlamp unit

20.02.2019

Model	118, 177, 247
	with code 620 (Halogen headlamps with integrated LED daytime running lights)

P82.10-8437-09

2	Cap	6	Electrical connector
3	Cap	E1	Left front lamp unit
5	Base	E2	Right front lamp unit

P82.10-8438-09

3	Cap	E1	Left front lamp unit
7	Base	E2	Right front lamp unit
8	Electrical connector

 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
 	Remove/install
1	Switch off exterior lighting.
2	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
	Remove low beam bulb
3	Move front wheels in end stop position, left or right.
4	Open service flap in fender liner on front axle at left or right.
5	Release and remove cap (2) from lamp unit at front left (E1) or lamp unit at front right (E2).
6	Release and disconnect electrical connector (6) from left low beam (E1e2) or right low beam (E2e2).
7	Turn base (5) in direction of arrow (arrow C) and remove.	If the left low beam (E1e2) or right low beam (E2e2) have to be replaced.
		 Do not touch glass bulb of left low beam (E1e2) or right low beam (E2e2) with your bare fingers; use a soft cloth free of oil and grease. Otherwise, the glass bulb will be damaged.
8	Install in the reverse order.
	Remove high beam bulb
9	Open hood.
10	Release and remove cap (3) from lamp unit at front left (E1) or lamp unit at front right (E2).
11	Release and disconnect electrical connector (8) from left high beam (E1e1) or right high beam (E2e1).
12	Turn base (7) in direction of arrow (arrow D) and remove.
13	Pull left high beam (E1e1) or right high beam (E2e1) out of base (7).	If the left high beam (E1e1) or right high beam (E2e1) have to be replaced.
		 Do not touch glass bulb of left high beam (E1e1) or right high beam (E2e1) with your bare fingers; use a soft cloth free of oil and grease. Otherwise, the glass bulb will be damaged.
14	Install in the reverse order.

Powiązane dokumenty

ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.