Remove/install additional brake lamp

AR82.10-D-5376TS

Remove/install additional brake lamp

06.03.2020

Model

907.6/7, 910.6

1

Screw

3

Additional brake lamp

4

Electrical connector

2

Seal

 Danger

Risk of death caused by falling from vehicle roof. Risk of injury to other persons caused by falling objects during work in roof area.

AS65.00-Z-0002-01A



Remove

1

Remove screw/bolts (1)

2

Carefully cut through seal (2) of additional brake lamp (3) along entire length


Do not carry out any lifting movements.
Otherwise damage will occur to the paint or to the body.

 Additional brake lamp (3) and seal (2) are not available separately as a replacement part.

 Clip remover

*452589016300

3

Remove additional brake lamp (3) until electrical connector (4) is accessible

4

Disconnect electrical connector (4) and remove additional brake lamp (3)



Install

5

Remove residue of seal (2) and soiling in installation area of additional brake lamp (3) at roof

Assembly cleaner

*BR00.45-Z-1028-04A

6

Position new additional brake lamp (3) at installation location and connect electrical connector (4)

 Do not detach backing from seal of new additional brake lamp (3).

7

Check additional brake lamp (3) and remaining exterior lighting for proper operation



AP82.10-D-8252TS


The function test of the additional brake lamp (3) must occur before adhesion.
Otherwise, if there is a malfunction, the additional brake lamp (3) will need to be replaced again because the seal (2) is destroyed during removal.

8

Detach backing of seal of additional brake lamp (3)

9

Press additional brake lamp (3) onto roof


Do not change installation position of additional brake lamp (3) after it has been pressed on.
Otherwise there will be damage to the seal (2).

10

Tighten screws (1)

Repair materials

Number

Designation

Order number

BR00.45-Z-1028-04A

Assembly cleaner

A 000 986 56 01