ar8210d4731ts

Remove/install rear lamp unit

Typ ar · temat 82.10 · wersja 0100 · 2018-03-29

Dotyczy: Model 907.6/7, 910.6

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 82 Układ elektryczny, nadwozie › 82.10 Oświetlenie zewnętrzne — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 30 Instalacja oświetleniowa › 30.15 Oświetlenie zewnętrzne › 30.15.41 Lampa tylna — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR82.10-D-4731TS

Remove/install rear lamp unit

15.03.2018

Model

907.6/7, 910.6

Remove/install rear lamp unit

D82.10-1205-09

Shown on right lamp unit (2)

1

Screw

3

Mounting clip

2

Headlamp unit

4

Electrical connector

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

2

Open left or right rear-end door.

3

Unscrew screw/bolts (1).

4

Unclip lamp unit (2) at retaining clips (3) to side and remove until electrical connector (4) is accessible.


Handle lamp unit (2) carefully.
Otherwise, the paint or the lamp unit (2) will be damaged.

5

Disconnect electrical connector (4) and remove lamp unit (2).

6

Install in the reverse order.

Check

7

Check exterior lighting for proper operation.

AP82.10-D-8252TS

Powiązane dokumenty