ar8050p9840h

Removing and installing ATA alarm signal siren

Typ ar · temat 80.50 · wersja 0104 · 2020-01-21

Dotyczy: Model 240

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 80 Zamek centralny, sterowanie komfortowe, układ uprawniający do jazdy › 80.50 Układ ostrzegania przed włamaniem i kradzieżą (EDW), zabezpieczenie wnętrza pojazdu/zabezpieczenie przed odholowaniem — Seria 240

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.20 System zabezpieczający przed kradzieżą i włamaniem › 29.20.20 Syrena — Seria 240

AR80.50-P-9840H

Removing and installing ATA alarm signal siren

09.01.2020

Model

240

Removing and installing ATA alarm signal siren

Shown on model 240.178

1

Nut

2

Bolts

3

Bracket

4

Electrical connector

5

Wiring harness clip

6

Screw

H3/1

Alarm signal horn with additional battery

P80.50-2315-06

Remove/install

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Danger

Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC.

No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

1

Disconnect battery ground line

AR54.10-P-0003H

Topical note

Notes on battery

AH54.10-P-0001-01A

2.1

Remove heater unit

Vehicles with stationary heater code 228.

AR83.70-P-5302HA

2.2

Remove finder liner in front fender

Vehicles without stationary heater code 228.

AR88.10-P-1300H

3

Remove nut (1)

4

Unscrew the screws (2) and remove the bracket (3) with the alarm siren with additional battery (H3/1) from the fender

5

Unclip the wiring harness clip (5) from the bracket (3)

6

Disconnect electrical connection (4)

Before removing the electrical connector (4), ensure that the antitheft alarm system (ATA) has been deactivated. Otherwise, the alarm siren with additional battery (H3/1) will be activated.

7

Unscrew the screw (6) and remove the alarm siren with additional battery (H3/1) from the bracket (3)

8

Install in the reverse order

Powiązane dokumenty