AR80.50-P-1000SN | Remove/install interior motion sensor | 16.9.02 |
MODEL 450.4 (except 450.418) with CODE (V02) Alarm system (relevant for service)
P80.50-2310-09
1 Electrical connector
2 Electrical connector
B39/6 Right front ATA [EDW] ultrasonic sensor
B39/5 Left front ATA [EDW] ultrasonic sensor
3 Electrical connector
6 IR interior motion sensor control module
P80.50-2309-06
4 Electrical connector
5 Electrical connector
B39/7 Left rear ATA [EDW] ultrasonic sensor
B39/8 Right rear ATA [EDW] ultrasonic sensor
| Remove/Install | ||
1 | Remove footwell cover on driver side | ||
2 | Remove footwell cover on front passenger side | ||
3 | Remove footrest on passenger side | ||
4 | Disconnect electrical connector (1). | ||
5 | Unscrew bottom nut from firewall and remove IR interior motion sensor control module (6) | ||
6 | Disconnect electric connector (2) | ||
7 | Unclip right front ATA ultrasonic sensor (B39/6) from A-pillar below instrument panel and remove | ||
8 | Separate electrical connector (3) | ||
9 | Unclip right front ATA ultrasonic sensor (B39/5) from A-pillar below instrument panel and remove | Installation: The left front ATA ultrasonic sensor (B39/5) is marked with a red tape. | |
10 | Remove left rear luggage box | ||
11 | Disconnect electrical connector (4) | ||
12 | Unclip left front ATA ultrasonic sensor (B39/7) and remove | ||
13 | Remove right rear luggage box | ||
14 | Disconnect electrical connector (5) | ||
15 | Unclip right front ATA ultrasonic sensor (B39/8) and remove | ||
16 | Install in the reverse order |