Install bellows on pop-up roof

AR77.70-S-0080-01E

Install bellows on pop-up roof

Model

447.7/8

with code ZK9 (Lifting roof hatch)

Model

447.8

with code ZK0 (EASY UP pop-up roof, electric)

Repair materials

Number

Designation

Order number

BR00.45-Z-1077-06A

Special lubricant, spray

A 000 989 35 60

1

Cut seven, approx. 10 cm long, fastening elements out of removed old filler profile (2).

2

Transfer markings on removed boot (1) to new boot (1).

If boot (1) is replaced.

3

Mark center of front profile rail (3).

4

Align markings on boot (1) according to markings on profile rails (3) and hook boot (1) into profile rails (3).

 The rear seam of the boot (1) is not located in the center due to design.

5

Install cut fastening elements on front center, front side, left, right and rear side.

6

Mark center of new filler profile (2).

7

Spray lubricant to filler channel (2).

8

Align center of filler channel according to marking on front profile rail (3), remove front fastening section and install front filler channel with  roller in front profile rail (3).

9

Starting at front, install boot and filler channel uniformly toward rear in profile rails (3) of pop-up roof using  roller and  long wedge.

 Remove fastening elements one after another.
Observe installation direction (arrows) of filler channel.

Shown on removed pop-up roof