Adjust manual pop-up roof in longitudinal axis

AR77.70-S-0001-04E

Adjust manual pop-up roof in longitudinal axis

Model

447.7/8

with code ZK9 (Lifting roof hatch)

Modification notes

02.12.2014

Screw/bolt, rear support clamp to vehicle roof

BA77.70-N-1002-01B

23.03.2017

Bolt, rear support clamp to vehicle roof

BA77.70-N-1002-01B

 Mechanical pop-up roof

Number

Designation

Model 447.7/8
with code ZK9 (Lifting roof hatch)

BA77.70-N-1002-01B

Bolt, rear support clamp to vehicle roof

Nm

8

1

Open pop-up roof (1).

2

Loosen bolts (5) at both rear set-up brackets (4).

3

Adjust rear set-up brackets (4) in direction of roof spoiler in longitudinal axis (x) on vehicle roof.

4

Tighten bolts (5)   .

5

Close pop-up roof (1).

Shown on right side of vehicle

6

Check distance dimension (b).

 The distance (b) must be approx. 10 to 12 mm.

7

Check whether sealing lip (6) is seated correctly on pop-up roof (1) with  long wedge.

 The sealing lip (6) should make contact with the rear edge of the offset on the roof spoiler (2) as shown. If the distance to the sealing lip (6) is not sufficient, adjust pop-up roof (1) again.
Otherwise the sealing lip (6) can be damaged when closing the pop-up roof (1).

 If the distance to the sealing lip (6) is not sufficient, adjust pop-up roof (1) again.
Otherwise wind noises can occur while driving.