P77.50-0300-06
1 Stop buffer
2 Nut
3 Guide arm
Adjustment | |||
1 | Remove paneling at front of vario-roof on side | ||
2 | Move vario-roof to installation position with roof switch | Leave ignition switched on. The vario-roof remains in this position for 7 min. after the roof switch is released (stop function). The roof can be set to this position for another 7 minutes by pressing the roof switch again. | |
3 | Loosen nut (2), screw in stop buffer (1) and close vario-roof | ||
4 | Unscrew stop buffer (1) until it makes contact with the guide arm (3), mark stop buffer (1) and move vario-roof to installation position | ||
5 | Unscrew stop buffer (1) two turns and tighten nuts (2) | ||
6 | Open and close vario-roof a number of times | If the vario-roof is subjected to excessive pressure downward in the area of the separation joint between the front section and rear section of the roof when locking, | |
unscrew stop buffer (1) one more turn | |||
7 | Install paneling on front of vario-roof at side |