Removing and installing cover between trunk lid and roll-bar · ar7750p3010g · Mercedes-Benz WIS

AR77.50-P-3010G

Removing and installing cover between trunk lid and roll-bar

14.8.96

MODEL 170

P77.50-0305-09

1 Rear cover
2 Front cover
3 Rubber strap

7 Attachment
8 Screw
9 Intermediate layer

4 Cable
5 Screw
6 Intermediate layer

P77.50-0311-06

Arrow Cable guide
Arrows Cover fit on trunk lid
1/2 Cover rear/front
Gap: 3-4 mm

7 Attachment
10 Pin
11 Nut
12 Stop bolt

 	Removal, installation
1	Open vario-roof
2	Remove cover above B-pillar		AR77.50-P-3000G
3	Unhook rubber strap (3) on main mount
4	Move vario-roof to installation position with roof switch	 Leave ignition switched on. The vario-roof remains in this position for 7 min. after the roof switch is released (stop function). The roof can be set to this position for another 7 minutes by pressing the roof switch again.
5	Unhook cable (4) on main mount	 Push hook for cable (4) back with pliers when installing
6	Unscrew screws (5), remove attachment (7) and cover (1)	 Do not mix up intermediate layers (6) when installing
7	Unscrew screws (8) and remove cover (2)	 Do not mix up intermediate layers (9) when installing
8	Reinstall in opposite order	 The pin (10) must engage in the opening in the attachment (7) when the vario-roof is put down.  Observe cable routing (arrow)  Adjust trunk lid fit (arrows) in relation to cover (1) with stop bolt (12).  Do not pull up side flap when vario-roof is opened, otherwise cable (4) can be damaged.