1 | Screw |
2 | Screw |
3 | B-pillar paneling |
4 | Carpet |
5 | Bolts |
6 | Soft top |
7 | Cover |
8 | Door seal |
P77.30-2259-06
9 | Plug connections |
10 | Line |
11 | Bolts |
P77.30-2260-04
12 | Luggage securing device |
13 | Screw |
14 | Seat belt guide bracket |
P77.30-2261-01
15 | Soft top assembly carrier |
P77.30-2303-01
| Remove/install | ||
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Notes on soft tops | |||
1 | Remove soft top canvas | ||
2 | Remove screw/bolt (1) | Lift the carpet (4). | |
3 | Unhook seat belt from seat belt guide at seat | ||
4 | Remove the cover from the seat belt guide bracket (14) and unscrew the screw (13) | The removal is shown on the left side of the vehicle. The removal is performed on the right side in the same way. | |
Bolt, upper seat belt guide bracket | |||
5 | Remove the luggage securing device (12) | Only model 452.3 | |
Pay attention to installation position. | |||
Bolt, divider to body | |||
6 | Unscrew the screw (2) from the B-pillar trim (3) | Bolt, soft top to B-pillar | |
7 | Remove the side support beams on the right and left | ||
8 | Pull cover (7) forwards | The removal is shown on the left side of the vehicle. The removal is performed on the right side in the same way. | |
9 | Pull off the door seal (8) in the area of the B-pillar trim (3) | ||
10 | Remove clips from B-pillar trim (3) and remove B-pillar trim (3) | ||
11 | Pull carpet (4) forward up to the rear panel | Do not overstretch the carpet (4). | |
12 | Remove bolt/bolts (5) | Remove the engine compartment cover carpet. | |
Bolt, soft top to body through engine compartment | |||
13 | Disconnect connectors (9). | ||
14 | Pull line (10) forward up to the rear panel | ||
15 | Remove covers and unscrew the screws (11) beneath them | Mark the location of the strut bearing in relation to the B-pillar before loosening the screws (11). | |
Bolt, soft top to body through engine compartment | |||
16 | Remove the soft top assembly carrier (15) toward the inside | Installation: Align the strut bearing with the marking of the B-pillar. | |
17 | Install in the reverse order | ||
18 | Adjust soft top |
Powiązane dokumenty
- ah7730p000101mco Wskazówki dotyczące dachu składanego
- ar7730p1010rr
- ar7731p1001rr
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.