S77.21-4557-09
Shown on removed panoramic roof |
1 | Wind deflector | 1.2 | Support | 2 | Screw | ||
1.1 | Cover | 1.3 | Spring | 3 | Pivot bearing |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Completely open panorama sliding roof | ||
2 | Switch off ignition | ||
3 | Unscrew bolts (2) | ||
Topical note | Notes on self-locking nuts and bolts | ||
4 | Unhook cover (1.1) from shackles (arrow A) | Installation: Press rear side of spring (1.3) toward front (arrow C) and then press wind deflector (1) downward, so that the shackles (arrow A) can be hooked in. | |
5 | Fold wind deflector (1) approx. 90° upward and remove from panoramic roof | Installation: Position mounts (1.2) of wind deflector (1) in pivot bearings (3). | |
| Check | ||
6 | Check left and right pivot bearing (3) for damage | If a pivot bearing (3) is damaged. | |
| |||
Lift shackle (arrow B) on damaged pivot bearing (3) with suitable screwdriver, push pivot bearing (3) toward rear, remove and replace with new pivot bearing (3) | |||
7 | Install in the reverse order | ||
| Check | ||
8 | By opening and closing the panoramic sliding roof, check whether the wind deflector (1) is folded out and in correctly. |
Powiązane dokumenty
- ah0000n000101a Wskazówki dotyczące samozabezpieczających śrub i nakrętek
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.