P77.21-2592-07
1 | Sliding roof cover | a | Front height offset | |
3 | Fixed glass section | b | Rear height offset | |
4 | Rear roof paneling |
P77.21-2589-08
1 | Sliding roof cover | 2 | Bolts |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Check | ||
1 | Close sliding roof panel (1). | ||
2 | Check front height offset (a) of fixed glass section (3) to sliding roof panel (1) and adjust if necessary. | Rear edge of fixed glass section (3) must be flush or lie max. 2 mm above sliding roof panel (1). | |
3 | Check rear height offset (b) of sliding roof panel (1) to rear roof paneling (4) and adjust if necessary. | Front edge of rear roof paneling (4) must be flush or lie max. 2 mm above sliding roof panel (1). | |
Adjust | |||
4 | Raise sliding roof panel (1) to tilt position and open until screws (2) can be accessed. | ||
5 | Release all screws (2) until sliding roof panel (1) can just be moved. | ||
6 | Close sliding roof panel (1). | ||
7 | Set front height offset (a) at sliding roof panel (1) so that rear edge of fixed glass section (3) is flush with or lies max. 2 mm above fully closed sliding roof panel (1). | The dimension of the front height offset (a) must be the same size over the entire width of sliding roof panel (1). | |
8 | Raise sliding roof panel (1) to tilt position and open until front screws (2) can be accessed. | ||
9 | Tighten front screws (2) at sliding roof panel (1). | ||
10 | Close sliding roof panel (1). | ||
11 | Set rear height offset (b) at left and right side of sliding roof panel (1) so that rear edge of sliding roof panel (1) is flush with or lies max. 2 mm above rear roof paneling (4). | The dimension of the rear height offset (b) must be the same over the entire width of sliding roof panel (1). | |
12 | Raise sliding roof panel (1) to tilt position and open until rear screws (2) can be accessed. | ||
13 | Tighten rear screws (2) at sliding roof panel (1). | ||
14 | Close sliding roof panel (1). | ||
Concluding tasks | |||
15 | Normalize panoramic sliding sunroof using vehicle diagnosis system and perform teach-in run for automatic reversing function. | ||
|
Powiązane dokumenty
- ad0000p200006mfa
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.