ar7720p2854fr

Remove/install sliding roof panel

Typ ar · temat 77.20 · wersja 0101 · 2018-07-02

Dotyczy: Model 257, 290 with code 414 (Sliding sunroof)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 77 Okno dachowe, dach składany, nasadki › 77.20 Okno dachowe przesuwane elektrycznie — Seria 257 · Seria 290

EinPAS 38 System dachu › 38.15 Okno dachowe przesuwne/ panoramiczne okno dachowe przesuwne › 38.15.33 Poszycie/pokrywa okna dachowego — Seria 257 · Seria 290

AR77.20-P-2854FR

Remove/install sliding roof panel

14.06.2018

Model

257, 290

with code 414 (Sliding sunroof)

Remove/install sliding roof panel

P77.20-2832-08

Shown on model 257 on the right side of the vehicle

1

Sliding roof cover

3

Sliding roof paneling

2

Bellows

4

Bolts

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Move sliding roof panel (1) to tilt position.

2

Open sliding roof trim (3).

3

Remove boot (2) on left and right.


Extend boot (2) on left and right first, then at bottom and then at top.
Boot (2) on left and right can otherwise be damaged by bending.

Installation: Only install boot (2) on left and right after adjustment.

4

Remove screws (4) on the left and right.

Installation: Tighten bolts (4) only after adjustment.

5

Remove sliding roof panel (1).

Helper required.

6

Install in the reverse order.

7

Adjust sliding roof panel (1).

AR77.20-P-1101FR

Powiązane dokumenty