Adjust tilting/sliding roof panel

AR77.20-P-1100TX

Adjust tilting/sliding roof panel

14.12.09



Removing

 Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Completely open sliding roof lining (1)

2

Open titling/sliding roof cover (3) approx. 20 cm.

3

Unclip covering (2) in center and side with assembly wedge, guide cover (2) out of rubber bellows (4) and remove



*110589035900

4

Completely close titling/sliding roof cover (3) and then move to tilt position

5

Remove rubber bellows (4) on left and right from tilting/sliding roof panel (3)

 Carefully remove rubber bellows (4) at top and bottom to prevent damage.

 Observe installation position of rubber bellows (4).

6

Close tilting/sliding roof panel (3)

Adjust

7

Loosen bolts (5) on left and right on tilting/sliding roof panel (3)

8

Insert cardboard strips (6) at rear into expansion joint for tilting/sliding roof panel (3)

 Cardboard strip (6) must be 500 mm long and approx.
1 to 2 mm thick.

9

Adjust tilting/sliding roof panel (3) in relation to exterior roof surface

 Observe measuring position (A) for height adjustment

*BE77.20-P-1001-01D

*BE77.20-P-1002-01D

10

Tighten left and right bolts (5) on tilting/sliding roof panel (3)

 Tighten bolts (5) from rear to front.



*BA77.20-P-1004-01F

11

Check tilting/sliding roof for proper function and correct tilting/sliding roof panel (3) match.



Install

12

Move tilting/sliding roof cover (3) into tilt position

13

Install rubber bellows (4) on left and right on tilting/sliding roof panel (3)

 Insert both rubber bellows (4) at top and bottom into guides Pay attention to installation position.

14

Close tilting/sliding roof panel (3)

15

Open titling/sliding roof cover (3) approx. 20 cm.

16

Position cover (2) in center and clip in

 Catch hook on cover (2) must arrest in center in both rubber bellows (4).

17

Close tilting/sliding roof panel (3)

18

Close sliding roof lining (1).

19

Perform learn-in procedure for tilting/sliding roof pinch protection



Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

STAR DIAGNOSIS diagnosis system

Number

Designation

Model
219

BE77.20-P-1001-01D

Gap dimensions

Tilting/sliding roof cover, front

mm

0.15

Tilting/sliding roof cover, on side and rear

mm

0.3

BE77.20-P-1002-01D

Height setting

Measurement position "A" (x)

mm

140

Front: deeper than outer skin of roof

mm

0 to 1

Rear: higher than outer skin of roof

mm

0 to 1

Number

Designation

Model
219

BA77.20-P-1004-01F

Bolt, tilting/sliding roof cover to tilt angle bracket

Nm

4