AR77.20-L-1000VA | Remove/install tilting/sliding roof panel | 18.12.06 |
MODEL 414 with CODE (DS9) Power glass tilting/sliding roof with sun screen
L77.20-0005-06
1 Trim
2 Tilting/sliding roof panel
3 Bolts
| Remove/install | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | |
1 | Push paneling (1) toward rear | ||
2 | Move tilting/sliding roof panel (2) into tilt position | ||
3 | Unscrew bolts (3) on both sides | | |
Torx bit set | |||
4 | Remove tilting/sliding roof panel (2) | Avoid damaging paint. | |
Mounting wedge | |||
5 | Remove cover strips on both sides. | Installation: Replace cover strips. Clean bonding area around cover strips and apply primer (Betaprimer 5061). Allow primer to air-dry for min. 10 minutes. | |
6 | Install in the reverse order | ||
7 | Adjust sliding roof. |
Electric sliding roof
Number | Designation | Model | ||
BA77.20-P-1002-01A | Bolt to sliding roof drive | Torx | Nm | 4 |
Hexagon socket | Nm | - | ||
000 589 01 10 00
Torx bit set
Assembly wedge
110 589 03 59 00
Powiązane dokumenty
- ar7720l1100va
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.