1 | Inner lock |
2 | Inner lock |
3 | Left rear door |
4 | Electrical connector |
5 | Bolts |
6 | Cable |
7 | Rotary tumbler |
S72.20-4659-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Remove inner lock (2) from left rear-end door (3) | ||
Detach inner lock (2) to remove inner lock (1). Do not remove cables from inner lock (2). | |||
2 | Mark installation position of inner lock (1) | ||
3 | Expose electrical connector (4) and disconnect | ||
4 | Expose electrical wiring harness for inner lock (1) front left rear-end door (3) | ||
5 | Remove screws (5) | ||
6 | Pull inner lock (1) downward and remove cable (6) from inner lock (1) | ||
7 | Guide inner lock (1) together with electrical wiring harness downward out of left rear-end door (3) and remove | ||
8 | Remove rotary tumbler switch from inner lock (1) | When replacing rotary tumbler switch or inner lock (1). | |
| Install | ||
9 | Install rotary tumbler on inner lock (1) | If rotary tumbler switch or inner lock (1) is replaced. | |
10 | Insert inner lock (1) with electrical wiring harness into left rear-end door (3) and install cable (6) | ||
11 | Tighten inner lock (1) with screws (5) | Observe markings. | |
12 | Connect electrical connector (4) and fasten electrical wiring harness | ||
13 | Install inner lock (2) on left rear-end door (3) | ||
Reinstall door paneling only after checking whether inner lock (1) is seated correctly in lock striker. | |||
| Check | ||
14 | Close rotary tumbler (7) on inner lock (1) with suitable tool | ||
15 | Actuate inner lock (2) and check whether inner lock (1) opens and arrests correctly | ||
16 | Check whether inner lock (1) is seated correctly in lock striker and tighten screws (5) | If it is necessary to correct the seat of the inner lock (1) in the lock striker: | |
| |||
Adjust inner lock (1) in relation to lock striker. | |||
Bolt, inner lock to rear-end door |
Powiązane dokumenty
- ar7220s4844e
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.