ar7240d1002c

Remove/install emergency release unit

Typ ar · temat 72.40 · wersja 0100 · 2014-07-22

Dotyczy: MODEL 900.6 with CODE T16 (Right load compartment sliding door) with CODE T55 (Electric operation of sliding door on right) with CODE T63 (Electric sliding door(s) unlocking) Inner emergency release unit

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.40 Sterowanie drzwiami — Seria 900 (modele 6**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.1 Informacje podstawowe — Seria 900 (modele 6**)

AR72.40-D-1002C

Remove/install emergency release unit

1.7.14

MODEL

900.6

with CODE T16 (Right load compartment sliding door)

with CODE T55 (Electric operation of sliding door on right)

with CODE T63 (Electric sliding door(s) unlocking)

Inner emergency release unit

Remove/install emergency release unit

D72.40-0023-07

1

Outer emergency release

6

Nut

2

Lever

7

Adjustment screw

3

Bolts

9

Screw-type nipple

4

Inner emergency release unit

10

Lever

5

Cable

Danger !

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove fuse 30 in seat base

By pulling fuse 30, the sliding door is not under tension and the buzzer does not sound when actuating the emergency release.

2

Actuate lever (2) on outer emergency release (1) and arrest

3

Actuate lever (10) on inner emergency release (4) and arrest

4

Remove bolts (3) from inner emergency release (4)

5

Slightly pull out emergency release (4) from sliding door

6

Unscrew bolt nipple (9) and pull cable (5) out adjustment screw (7)

Installation: Adjust adjustment screw (7) so that play is no longer present without load on inner emergency release (4) for control cable (5) lever (10).

When replacing inner emergency release (4), transfer adjustment screw (7) with nut (6).

7

Install in the reverse order

Learn in electric sliding door

8

Completely open sliding door with switch on center console and close again

Check

9

Perform function test

Powiązane dokumenty