S72.20-4626-08
1 | Hinge | 4 | Vent windows | |
2 | Screw | 5 | Liftgate | |
3 | Nuts |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open vent window (4) | ||
2 | Mark installation position of hinge (1) on vent window (4) and liftgate (5) | ||
3 | Unscrew nuts (3) from left and right hinge (1) | Helper required. | |
Change hinges (1) one after another. | |||
Installation: Observe corresponding markings. | |||
Nut, hinge to pop-out window | |||
4 | Unscrew bolt (2) and remove corresponding hinge (1) | Helper required. | |
Installation: Observe corresponding markings. | |||
Bolt, hinge for pop-out window to liftgate | |||
5 | Install in the reverse order | ||
| Check | ||
6 | Check gap dimension "HB" between vent window (4) and liftgate (5) | Gap dimensions | |
Feeler gauge | |||
In the event of complaints: | |||
| |||
Adjust gap dimension "HB". | |||
Nut, hinge to pop-out window | |||
Bolt, hinge for pop-out window to liftgate |
Check gap dimensions |
Number | Designation | MODEL 447 with CODE W65, MODEL 447 with CODE W68 | |||
BE60.00-N-1008-01J | Check gap dimensions | Rear window in liftgate, all-round | Dimension "HA" | mm | 4 (1) |
Folding rear window in liftgate, all-round | Dimension "HB" | mm | 4 (1) | ||
Liftgate to taillamp | Dimension "HC" | mm | 4,5 (1) | ||
Liftgate to bumper at side | Dimension "HD" | mm | 4 (1) | ||
Liftgate to bumper at bottom | Dimension "HE" | mm | 6 (1,5) | ||
Liftgate to roof frame | Dimension "HF" | mm | 5,5 (1) | ||
For picture, see | |||||
129 589 03 21 00
Feeler gauge
Powiązane dokumenty
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.