ar7220s2420e

Remove/install outside door handle on rear-end door

Typ ar · temat 72.20 · wersja 0100 · 2014-06-16

Dotyczy: MODEL 447.6/7 with CODE W50 (Rear-end door, double-wing, 180 degrees without window) MODEL 447.6/7 with CODE W54 (Hinged rear doors, opening to side wall)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 447 (modele 6**, 7**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 447 (modele 6**, 7**)

AR72.20-S-2420E

Remove/install outside door handle on rear-end door

02.06.2014

MODEL

447.6/7

with CODE W50 (Rear-end door, double-wing, 180 degrees without window)

MODEL

447.6/7

with CODE W54 (Hinged rear doors, opening to side wall)

Remove/install outside door handle on rear-end door

S72.20-4654-09

1

Outer door handle

4

Screwdriver

2

Right rear door

5

Latch

3

Grommet

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Remove grommet (3)

2

Pull out outer door handle (1) and loosen bolt on bearing bracket with screwdriver (4)

Removal: The bolt on the bearing bracket is sufficiently loosened when the outer door handle (1) remains in the pulled position by itself as shown.

Installation: Press on lock (5) and tighten bolts on bearing bracket until a perceptible resistance can be felt on the screwdriver (4). Outer door handle (1) automatically jumps back to initial position if it correctly installed.

3

Remove latch (5)

4

Pull outer door handle (1) toward rear as shown and remove

5

Install in the reverse order

Check

6

Check outer door handle (1) for proper function

Powiązane dokumenty