S72.20-4616-09
1 | Outer cover | 4 | Nut | |
2 | Vent windows | 5 | Long wedge | |
3 | Screw | E21/3 | 3rd brake lamp, separately opening rear window |
S72.20-4617-07
1 | Outer cover | 10 | Windshield washer hose | |
6 | Wiring harness | 11 | Electrical connector | |
7 | Mounting clip | 12 | Electrical wiring harness | |
8 | Retaining clip mount | E21/3 | 3rd brake lamp, separately opening rear window | |
9 | Rear window spray nozzle |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open pop-out window (2). | ||
2 | Remove screw (3). | ||
3 | Remove covers from nuts (4) and unscrew nuts (4). | ||
4 | Close pop-out window (2). | ||
5 | Insert long wedge (5) as shown between the outer trim (1) and the pop-out window (2) and unclip left and right retaining clip (7) from the retaining clip mounts (8). | Insert long wedge (5) at a distance of approx. 5 cm from the outsides of the center high-mounted brake lamp of the rear window (E21/3) to be opened separately. | |
Long wedge | |||
6 | Disconnect electrical connector (11) from the center high-mounted brake lamp of the rear window to be opened separately (E21/3). | ||
7 | Remove electrical wiring harness (12) from the outer trim (1). | Observe assembly position of electrical wiring harness (12). | |
8 | Remove windshield washer hose (10) from the rear window spray nozzle (9). | Observe installation position of windshield washer hose (10). | |
9 | Remove wiring harness (6) from the outer trim (1) and remove outer trim (1). | Observe installation position of wiring harness (6). | |
10 | Install in the reverse order | ||
| Check | ||
11 | Perform function test on additional brake lamp (1). | ||
Danger | Risk of fire and explosion caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin. | Wear protective clothing and tight-fitting safety glasses. No open flames, fire or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children. | |
Warning | Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | |
12 | Perform leak test on rear window spray nozzle (6). | If leaks occur, | |
| |||
make sure sealing ring and retainer (5) are correctly seated. | |||
13 | Check spray nozzle adjustment for rear window windshield washer system. | ||
|
115 589 03 59 00
Long wedge
Powiązane dokumenty
- ap8230s8252e Kontrola działania wycieraczek, spryskiwaczy szyby, układu zmywania reflektorów
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.
- as8230z000101a Niebezpieczeństwo zakleszczenia lub zmiażdżenia, w skrajnym przypadku obcięcia kończyn podczas prac przy układzie mechanicznym wycieraczki
- as8235z000101a Niebezpieczeństwo pożaru i wybuchu na skutek zapalenia się środków do czyszczenie szyb, środków chroniących przed zamarzaniem i ich oparów. Niebezpieczeństwo zatrucia na skutek połknięcia środków i wdychania oparów.