ar7220p2120rg

Remove/install door frame seal of liftgate

Typ ar · temat 72.20 · wersja 0101 · 2016-11-14

Dotyczy: Model 190

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 190

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.36 Pokrywa/ klapa › 35.36.33 Klapa tylna/ klapa bagażnika — Seria 190

AR72.20-P-2120RG

Remove/install door frame seal of liftgate

08.11.2016

Model

190

Remove/install door frame seal of liftgate

P72.20-3398-09

2

Trim Panels

5

Assembly wedge

3

Retaining clips

6

Rear bumper

4

Sealing frame on liftgate

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Remove rear center assembly paneling

AR68.30-P-4785RG

2

Unclip paneling (2) and remove

Check retaining clips (3) for damage and in event of complaint

Replace the retaining clips (3).

3

Remove sealing frame from liftgate (4)

Installation: Install sealing frame on liftgate (4) below rear bumper (6) using assembly wedge (5).

Model 190
except code M030 (GT R version)
Installation: It mus be ensured that the sealing frame of the liftgate (4) is seated correctly. The abutting edge should be centered at the top of the short side.

Model 190
with code M030 (GT R version)
Installation: It mus be ensured that the sealing frame of the liftgate (4) is seated correctly. The abutting edge should be centered at the bottom of the short side.

Mounting wedge

*110589035900

4

Install in the reverse order

Remove/install door frame seal of liftgate

110 589 03 59 00

Mounting wedge

Powiązane dokumenty