P72.20-2210-09
1 Rear-end door paneling
2 Rear-end door seal
3 Bolt
E19/1 Left license plate lamp
E19/2 Right license plate lamp
4 Bolts
5 Electrical connector
6 Electrical connector
P72.20-2211-04
7 Smart model plate
8 cdi model plate
a 465 mm
b 465 mm
c 20 mm
d 985 mm
e 30 mm
f 80 mm
| Remove/install | ||
1 | Remove rear license plate | ||
2.1 | Remove rear license plate | Model 450.3, Canada, code L27 | |
Installation: When replacing rear-end door paneling (1): | |||
Install rear license plate | |||
3.1 | Remove license plate adapter plate | Model 450.3, Japan, code L16 | |
Installation: When replacing rear-end door paneling (1): | |||
Install license plate adapter plate | |||
Riveter | |||
4 | Pull rear-end door seal (2) of rear-end door paneling (1) | ||
5 | Loosen bolt (3) on rear-end door paneling (1) bracket | ||
6 | Unscrew bolts (4) on left and right from rear-end door paneling (1)n | ||
7 | Press rear-end door paneling (1) downward out of catch lugs on inner section (arrow) and pivot downward until electrical connector (5, 6) on license plate lamps is accessible. | ||
8 | Disconnect license plate lamp from electrical connector (5, 6) | Do not damage catch lugs as otherwise connector will no longer be locked in place. | |
9 | Remove rear-end door paneling (1) | When replacing rear-end door paneling (1) transfer bracket, lock seal and license plate lamp. | |
10 | Install in the reverse order | ||
11.1 | Glue on smart model plate (7) according to dimensions specified. | Model 450.3 | |
Only when replacing rear-end door paneling (1). | |||
Dimensions, see figure A. | |||
12.1 | Glue on cdi model plate (8) according to dimensions specified. | Model 450.3 with engine 660.940 | |
Only when replacing rear-end door paneling (1). | |||
Dimensions, see figure B. |
Riveter
450 589 00 39 00