D72.20-1281-79
Shown on model 907.7 |
1 | Door handle | 4 | Screw | |
2 | Rear-end door | 5 | Latch | |
3 | Plug | 6 | Seal |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open rear-end door (2). | ||
2 | Remove stop plug (2). | ||
3 | Pull out door handle (1) in direction of arrow (arrow A), hold in this position, and release screw (4) by approx. 5 revolutions. | Removal: The screw (4) on the bearing bracket is sufficiently loosened when the door handle (1) remains in the pulled position of its own accord, as shown. | |
Installation: Press on lock (5) and tighten screw (4) on bearing bracket until a perceptible resistance can be felt on the screwdriver. If it is installed correctly, the door handle (1) jumps back to the initial position by itself. | |||
4 | Remove latch (5). | Installation: Ensure that the seal (6) is seated correctly on the rear door (2). | |
5 | Release door handle (1) in direction of arrow (arrow B) and remove from rear door (2) in direction of arrow (arrow C). | ||
6 | Install in the reverse order. | ||
| Check | ||
7 | Check door handle (1) for proper function. |
Powiązane dokumenty
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.