AR72.20-D-1901C | Remove/install rear-end door | 25.11.10 |
MODEL WD1, WD2, WD3, WD6, WD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7
MODEL 903.66 /67, 904.66 with CODE (ZU7) National version for Canada
MODEL 903.66 /67, 904.66 with CODE (ZU8) National version for USA
MODEL 903.66 /67, 904.66 with CODE (ZU9) National version for Mexico
D72.20-0002-09
Illustration: flat roof version
5 Right strap
6 Left strap
7 Paint protective sheet
8 Door stop
1 Left rear-end door
2 Rear-end door, right door wing
3 Cylindrical torx screw
4 Torx screw
Modification notes
| Remove/install | ||
1 | Check door check (8) on both door hinges. | replace if necessary. | |
2 | Release strap (5) | ||
3 | Inspect paint protective sheets (7) for damage | replace if necessary. | |
4 | Remove screws (3, 4) attaching door hinges | | |
5 | Lift out rear door | The left rear-end door is removed in the same way. | |
If the door is replaced, the seams must be sealed all around before painting | |||
Installation: Clean door hinge contact surfaces before installing rear-end door and apply primer. | |||
6 | Install in the reverse order | ||
7 | Inspect alignment of rear door | Adjust if necessary. |
Rear-end door