Remove/install inside door handle on sliding door

AR72.16-D-6601TS

Remove/install inside door handle on sliding door

18.06.2018

Model

907.6/7, 910.6

Modification notes

04.06.2018

Normalization of electric sliding door added.

Step 9

Shown on model 907.6 with code T55 (electrical actuation for right sliding door)

15

Release

Shown on model 907.6 except code T55 (Electrical actuation for right sliding door)

1

Cover

3

Door handle

5

Cable

2

Screw

4

Cable

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Open sliding door approx. 50 cm wide.

2

Set release (15) to "MAN" position using a suitable screwdriver.

Model 907.6/7
with code T55 (Electric operation of sliding door on right)
with code T56 (Electric operation of sliding door on left)

 This deactivates the sliding door electric drive.

3

Remove covers (1).

4

Unscrew bolts (2).

5

Remove door handle (3) from sliding door until cable (4) is accessible.

6

Remove cable (4) from door handle (3).

7

Remove cable (5) from door handle (3).

Model 907.6/7
except code T55 (Electric operation of sliding door on right)
except code T56 (Electric operation of sliding door on left)
Model 910.6

8

Install in the reverse order.

9

Completely open and close sliding door twice with corresponding push button switch.

Model 907.6/7
with code T55 (Electric operation of sliding door on right)
Model 907.6/7
with code T56 (Electric operation of sliding door on left)

 For normalization of electric drive of sliding door.
Keep push button switch pressed throughout normalization run.



Check

10

Perform function check of door handle (3).