ar7216d102303f

Install rubber buffer on sliding door

Typ ar · temat 72.16 · wersja 0200 · 2015-10-01

Dotyczy: Model 909

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.16 Drzwi przesuwane — Seria 909

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.35 Drzwi › 35.35.44 Drzwi przesuwne — Seria 909

AR72.16-D-1023-03F

Install rubber buffer on sliding door

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Model

909

Modification notes

3.9.15

Installation position of upper spacers changed.

Operation step 1

3.9.15

Dimensions for bonding spacers to B-pillar changed.

The spacers (7) are installed to prevent damaging the B-pillar when the sliding door is slammed.

Install rubber buffer on sliding door

1

Glue upper spacer (7) with distance (a) below upper catch (8) to B-pillar.


Glue upper spacer (7) at outer edge (arrow) to B-pillar.
This ensures that the sealing frame is not pinched between the sliding door and spacers (7) when closing the sliding door.


Dimension a 50 mm


a

Distance

D72.16-1361-01

Install rubber buffer on sliding door

2

Glue lower spacer (7) with distance (b) below lower catch (8) to B-pillar.


Glue lower spacer (7) at outer edge (arrow) to B-pillar.
This ensures that the sealing frame is not pinched between the sliding door and spacers (7) when closing the sliding door.


Dimension: b 45 mm


b

Distance

D72.16-1335-01

Powiązane dokumenty