Adjust evenness, installation depth and stop of sliding door

AR72.16-D-1023-02F

Adjust evenness, installation depth and stop of sliding door

Model

909

Modification notes

4.5.15

"Install guide wedges (9)" added.

Operation step 8

26.10.15

Tightening torque for adjustment screw of lower and upper sliding carriage inserted added

Operation step 3, 4

 Sliding doors

Number

Designation

Model 909

BA72.16-N-1003-01A

Bolt, guide wedge to sliding door

Nm

10

 Sliding doors

Number

Designation

Model 909

BA72.16-N-1009-01A

Bolt, sliding door stop on sliding door

8.8

Nm

10

10.9

Nm

-

 Sliding doors

Number

Designation

Model 909

BA72.16-N-1017-01A

Bolt, lock striker to C-pillar

Nm

25

 Sliding doors

Number

Designation

Model 909

BA72.16-N-1022-01A

Adjustment screw for lower/upper carriage

Lower

Nm

10

Upper

Nm

12

1

Remove bolts (6, 7).

2

Adjust flatness by moving upper and lower carriage.

 The installation depth should be flush to 1 mm inward.

3

Tighten screw/bolt (6)  .

4

Tighten screw/bolts (7)  .

5

Loosen bolts (8).

6

Move locking eye horizontally and adjust rear installation depth.

 Adjust rear installation depth flush or with 1 mm protrusion.
Ensure that striker pin runs into center of lock striker.

7

Tighten screw/bolts (8)  .

8

Install guide wedges (9).

 Tighten bolts (5) so that the guides wedges (9) can still be moved.

9

Adjust position of guide wedges (9) in relation to sliding block (10) by moving in direction of arrow (arrows A, B).

 Closing the sliding door centers the guide wedge (9) in relation to the sliding block (10).
Ensure that the door seal is not damaged by the guide wedges (9) or sliding block (10).

10

Screw bolts (5) tight  .

11

Loosen bolts on sliding door stop (11).

12

Open sliding door and hold end position.

13

Hold sliding door stop (11), position at C-pillar with zero clearance and tighten bolts on sliding door stop (11)  .